Leetro MPC6575 User Manual

MPC6575-Close-loop Laser Engraving &Cutting Controller (Rev. 1.0)
28
1) : Press Esc button to return to the main interface.
2)
: Press this button to generate the bordering motion.
3)
: Press this buttonto start point shooting of laser. Laser time and power can be set in
Laser Set interface.
4)
: Press this button the start the processing. During the processing, button can
also be used as pause/resume button
.
5)
: Press this button to pause the processing. When the processing is paused, press
again to resume the work.
6)
: Press this button to stop the processing, and the laser head will move to the starting
point of the processing.
Remark:
button is used for emergency stop. Press button in high-speed
movement will cause severe strick to the laser machine.
button is used for deceleration
stop. It is suggested press
button first during processing. And press to stop the
processing when the work is paused.
7.1.8 USB Stick Download Interface
Once USB stick is detected plug in MPC6575, the user interface would shift to the USB stick
download interface automatically.
In this interface the download status will be shown in the display. When 100% work is
downloaded to the controller, the text display shows the message Remove USB Stick. When the
USB stick is pulled out as commanded, the text display shows the message Download Completed.
Press
to return to the main interface.

Leetro MPC6575 Specifications

General

Brand	Leetro
Model	MPC6575
Category	Controller
Language	English