Leetro MPC6575 - 5.7 Download from USB Stick; Chapter 5.8 Error Alarm Interface; 5.8.1 Introduction; 5.8.2 Stop Caused by Soft Limit

MPC6575-Close-loop Laser Engraving &Cutting Controller (Rev. 1.0)
12
Once the processing finished, only Start/Pause, and Esc buttons can be effective.
To enter the processing interface, press Start/Pause.
To return to the main interface, press Esc.
5.7 Download from USB Stick
Return to the main interface, plug the USB stick into the controller and the user interface of
PAD03 will display as follows:
Once the USB stick is detected without error, the controller starts downloading the processing
file from the USB stick. User interface of PAD03 displays as follows:
Once the downloading completed, the buzzer starts ringing, and the user interface displays as
follows:
Once the USB stick is pulled out, the ringing ceases.
5.8 Error Alarm Interface
5.8.1 Introduction
If any error occurred during the operation, the user can read the error message with PAD03
directly.
5.8.2 Stop Caused by Soft Limit
DETECTING USB FLASH
DISK
DOWNLOADING
STATUS: 000%
DOWNLOAD COMPLETED
REMOVE USB FLASH DISK
SOFT LIMIT.
PROCESSING STOP