FAQ
41
11.4.2 Instruction
Pin OUT1(Blow off ON/OFF signal) in MPC6575/MC board is controlled by the machining
commands during the processing. The blow-off device will be on when the port is low-voltage. When
the port is high-voltage, blow-off device will be off.
11.5 Grade Engrave
11.5.1 Functionality
The grade engraving power table should be set according to specifications of the laser power
supply and laser tube applied to the machine.
11.6 Soft Limit under Immediate Mode
Functionality
This functionality is effective only on the premise that the machine has been to the origin point.
Machine will auto-detect if the processing file exceed the worktable range before output.
11.7 Control Two Laser Heads
Functionality
Control the power of the two laser heads independently.
Instruction
Set power mode to “LaserPowerMode=4”, and set the distance of two laser heads.
To Previous Page
Loading...
