Touch Screen
23
Parameter Descriptions:
z File: Current file name.
z Speed: Current percentage of the processing speed. The percentage of speed can be adjusted
on-the-fly by pressing
and buttons within the range of 0-100%.
z Power: Current percentage of processing power. The percentage of laser power at high-speed
can be adjusted on-the-fly by pressing
and buttons within the range of 0-100%.
z Pcs: The workpieces have already been processed.
z Status: Current work status. Touch screen will display the current status, i.e. Processing, Finished,
or Pause according to the practical process status automatically.
z Time: Elapsed time of the processing.
z Start/Pause: Press this button to start the processing or to pause the processing on-the-fly. When
the laser paused, press this button again to resume the work.
z Stop: Press this button to stop the processing and moves the laser back to the starting point of
the process.
z Esc: Press Esc to return to the main interface.
6.3.7 Status Interface
Once download signal of USB stick or datum signal is detected by MPC6575, Following
message would pop up automatically.the user interface would shift to the USB stick download
interface automatically.
z Datum signal detected: Datum, please wait… The message box will close automatically if datum
motion stops.
z Download signal of USB stick detected: First the message Detecting USB stick… is to pop up. If
the USB stick is detected without error, download status will be shown. When the download
completed, message Completed! Remove the USB Stick… pops up. Once the USB stick is
pulled out as commanded, message box would close automatically.
To Next Page
Loading...
Need help?
General
