Leetro MPC6575 User Manual

MPC6575-Close-loop Laser Engraving &Cutting Controller (Rev. 1.0)
20
Three language options can be found in the menu interface such as Simplified Chinese (GB),
Traditional Chinese (BIG5), and English.
The other three options are Laser Set, Jog Set and Main Interface.
6.3.3 Laser Interface
Press the Laser button in the menu interface to enter the Laser interface.
Laser time and power can be set in this interface. The default laser time is 0millisecond, and can
be edited within the range of 0-99999ms. The default percentage of laser power is 100%., and can
be edited within the range of 0-100%.
If the laser time is 0ms, user can hold down the Laser button to generate laser beam and loose
the button to stop the laser beam. If the laser time is set to be 100ms, for example, each time the
user press the Laser button the laser beam will be generated for 100ms.
Press Esc to return to the menu interface.

Leetro MPC6575 Specifications

General

Brand	Leetro
Model	MPC6575
Category	Controller
Language	English