Leetro MPC6575 - 11.2.1 Functionality; 11.2.2 Instruction; 11.3 External Process Completion Indicator Light; 11.3.1 Functionality

MPC6575-Close-loop Laser Engraving &Cutting Controller (Rev. 1.0)
40
Remark:
K9=GND
User can design the panel according to the above wiring figure.
11.3 External Process Completion Indicator Light
11.3.1 Functionality
To guarantee the operation safty, the process completion indicator light functionality is developed
for confirming what the current processing status is before operating. It is used for leading out the
processing status signal to the control panel to drive an LED or other indicator light showing the
processing status.
11.3.2 Instruction
Pin OUT2 (Process completion indicator light signal) in MPC6575/MCV1.1 board can be used for
driving relay or LED to indicate if the process is completed.
11.4 Blow-off
11.4.1 Functionality
Blow-off switch controlled through the I/O interface can be used for blowing off the heat and ash
produced during the laser engraving and cutting process.
Reserve
Down
Esc
Up
Enter
Left
Menu
Laser
Start
Pause
Right
Test
Stop
Datum
Z
K1
K2
K4
K5
K6
K7
K8
K9
Reserve Reserve
Reserve
Reserve
Reserve
Reserve Reserve Reserve
Reserve
ReserveReserve Reserve Reserve