Version 3.3 19
Keypad & Display Description Operator’s Manual
depressions on the function key (when not in the edit mode) allow
you to page through all of the screens available for that particular
function. You can accomplish the same thing by selecting a
function and using the left and right arrows on the cursor key
(which is sometimes faster). Whichever method you choose, it is
impossible to get lost between function screens. In addition, the
software remembers which screen you used last for each function.
Each time you reenter a function (i.e. you go from PLOT to NAV),
you will enter the last screen you viewed for that function. You can
change this setting in the CFG 1 Operation.
Use the associated function key to access the international character
desired (i.e. A for Æ). The international characters supported are:
ABC = Ä, Å, Æ, À, Ç
DEF = É, È
GHI = Í
MNO = Ñ, Ó, Ö
STU = Ú, Ü
Use the CFG key when in the edit mode to cycle through these
other optional characters.
‘ “ $ & ! ( ) ? / + - ° . , :
To Next Page
Loading...
