80 Version 3.3
Operator’s Manual Plot
displayed. No causes the course lines not to be displayed. Note
that these lines can only be displayed in Rhumb Line navigation
mode (see CFG1 Navigation).
Ø Show Recorded Track - Yes is the default condition, which
causes the course you have already traveled to be displayed. No
causes the traveled course not to be displayed.
Ø Show Off Track Limit - Yes is the default condition, which
causes the active route cross-track error lines to be displayed.
These are only displayed for the leg of the course you are
presently on. If you reset your cross-track error, these lines are
redrawn to reflect the course change (see NAV2). No causes the
cross-track error lines not to be displayed. Note that these lines
can only be displayed in Rhumb Line navigation mode (see
CFG1 Navigation).
Ø Show Lat/Lon Grid - No is the default condition, which causes
the coordinate grid not to be displayed. Yes causes the Lat/Lon
grid to be displayed (regardless of positioning reference system
selection in CFG1 Position). Note that the grid is only displayed
at the 4Nm scale or lower.
To Next Page
Loading...
