5.4002.8501.0 B
Troubleshooting 8-15
Symptom
Possible cause
Action
2. Examine in the bluetooth settings of the
smartphone if the machine is paired. If
not, try to pair (PIN = '0000').
Refer to the user manual of the
smartphone.
The machine is
switched OFF.
Switch ON the Machine (see page 5-4).
The distance between
the smartphone and
the machine is too big
Move the smartphone towards the machine
and try to connect (see Start the Lely
Control Application on page 5-5).
The vehicle does not move. machine is switched
OFF.
Switch ON the Machine (see page 5-4).
Put the machine into operation (see Start,
Stop or Pause a Manual Route on page 5-
33).
The route is blocked. Remove the blockade.
The battery is low. Drive the Machine to the Charging Station
(see page 5-7).
Charge for one hour.
The fuse is blown. Call your local Lely service provider.
The power supply is
not connected.
Connect the power supply.
Other. Call your local Lely service provider.
The machine drives more shaky
than before.
The chains are not
tightened correctly.
Call your local Lely service provider.
The wheel bearing is
worn out.
Call your local Lely service provider.
Machine swings. The gyroscope is
drifting.
Calibrate the Gyroscope (see page 8-19).
The ultrasonic sensor
does not function
correctly.
Clean the Ultrasonic Sensor (see page 6-4).
Test the ultrasonic sensor (see Test the
Ultrasonic Sensor on page 7-6).
Other. Call your local Lely service provider.
Machine does not stop at the
charging station.
The charging strips or
electrodes do not
make contact.
Clean the Charging Strips and the Charging
Electrodes (see page 6-2).
No power supply. Make sure the charging station is connected
to the power supply.
Springs that hold the
electrodes are loose.
Attach the springs properly.
The 'Go to the
charger' action is not
• Modify a Route (see page 5-28).
in n o vato rs in ag ricu ltu r e
To Next Page