4.1059.8506.0 A
6-2 Operating Instructions
2. Adjust the tractor’s three-point hitch arms to an equal height.
3. Fit the lower arms of the three-point hitch to the linkage pins (4)
(cat II) of the headstock (1) (see figure 12 on page 6-3).
4. Attach the top link of the tractor to the headstock of the rake with
a top link pin (2) (cat II).
5. Lift the headstock until the rake is in a horizontal position.
6. Switch off the tractor engine and remove the key.
7. Put the parking jack (3) in the raised position.
8. Secure the tractor’s lower arms with stabilisation chains or rods to
eliminate any sideways movements.
9. Make sure the PTO shaft (5) of the rake telescopes smoothly.
10. Connect the PTO shaft to the tractor PTO.
11. Connect the safety chain of the protection tube to a rigid part of
the tractor.
12. If the rake has a lighting kit (optional):
1. Insert the plug of the lighting cable into the socket of the
tractor. Make sure the lights operate correctly.
To Next Page
Loading...
