LELY HIBISCUS 455 - Preventive Maintenance Procedures; Lubricate the PTO Shaft

4.1059.8506.0 A
8-2 Maintenance
Lubricate the lower rotor wheel assembly (see page 8-
5).
X X
Lubricate the gearbox of the rotor (see page 8-4).
X X
Make sure the PTO shaft telescopes smoothly.
X X
Make sure the rake is not damaged. Repair or replace
damaged parts.
X X
Make sure the tyre pressure of the rotor wheels is
correct (see page 8-16).
X X
Torque tighten all bolts and nuts.
X
Torque tighten the nuts of the tine arm carriage bolts
(see page 8-11).
X
Make sure all safety decals are legible and not
damaged. Replace if necessary (see page 2-5).
X
8.2 Preventive Maintenance Procedures
8.2.1 Lubricate the PTO shaft
Requirements
• Grease pump
• Biodegradable grease (SEP2)
Procedure
1. Take the rake out of operation (see page 6-12).
2. Lubricate the following grease points of the PTO shaft:
• The grease nipples of the universal joint (A).
• The grease nipples of the guard bearing (B).
• The profiled tubes (C).
• The grease nipple of the clutch (D).