4.1059.8506.0 A
6-6 Operating Instructions
Figure 15. Secure the steering device with the locking pin
KEY:
1. Locking pin
6.4 Put the Rake into the Working Position
Make sure that no-one is near the rake when it is moved from the
transport position to the working position.
Put the rake in the working position as follows:
1. Pull out the locking pin, move it to the top position and release it
to unlock the steering device.
2. Move the three-point hitch of the tractor downwards to lower the
rake onto the ground.
3. Remove the tine arms from the holders and install them on the
rotor.
4. Pull the locking bar (2) (see figure 13 on page 6-4) and unfold the
safety guard to the horizontal position. Do this at both sides of the
rake.
To Next Page
Loading...
