4.1059.8506.0 A
Operating Instructions 6-1
6 OPERATING INSTRUCTIONS
Ensure no-one is near the rake at the moment the PTO is
engaged.
If anyone comes near the rake immediately stop the tractor and
disengage the PTO.
Switch off the tractor engine and remove the key before leaving
the tractor cabin.
The safety guards and the swath curtain are essential protective
components of the rake. Only operate the rake if these
components have been duly fitted.
6.1 Before operating the Rake
Before connecting or operating the rake:
• Make sure the procedures described in chapter ‘First Use’ are done
(see page 5-1).
• Make sure preventive maintenance is done (see page 8-1).
• Visually inspect the rake. Make sure the rake is not damaged. Make
sure damaged parts are replaced or repaired.
• Make sure the required adjustments are done (see page 7-1).
• Make sure the PTO shaft is not damaged and telescopes smoothly
and its safety covers and chain(s) are present and not damaged.
• Make sure all safety guards and protection devices are installed
and function correctly.
6.2 Connect the Rake to the Tractor
During first assembly or when using another tractor, check the minimum
and maximum overlap of the PTO shaft halves in all positions. Consult
the instructions supplied with the PTO shaft and the instructions in
chapter ‘First Use’.
Make sure that the front axle weight of the tractor is sufficient and that
the permitted maximum rear axle weight is not exceeded. Refer to the
manual of the tractor.
Connect the rake to the tractor as follows:
1. Engage the parking brake of the tractor.
To Next Page
Loading...
