EasyManua.ls Logo

LEMKEN Diamant 11 - 6 Preparation of the Tractor; 6.1 Tyres; 6.2 Lift Rods; 6.3 Check Chains or Sway Blocks of the Three Point Linkage

LEMKEN Diamant 11
137 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preparation of the Tractor
42
6 PREPARATION OF THE TRACTOR
6.1 Tyres
The pressure - especially in the rear tractor tyres - must be equal. In heavy condi-
tions it may be necessary to add wheel weights and/or water ballast. (See manu-
facturer’s instructions).
6.2 Lift Rods
Adjust lift rods to equal length. (See manufacturer’s instructions).
6.3 Check Chains or Sway Blocks of the Three Point Linkage
Check chains or sway blocks must be adjusted so that the lower links of the trac-
tor cannot move sideways during work.
6.4 Exterior width of the tractor
The maximum permissible exterior width of the tractor must not exceed 300 cm. If
this dimension is exceeded, the extent to which the tractor can steer into the im-
plement is restricted.
CAUTION
Risk of collision and damage
When steering the tractor in, the tyres or parts of the tractor must
never come into contact with the plough bodies.
6.5 Control
For operation and transport the tractor hydraulic is to be switched to “position con-
trol”. See manufacturer's instructions!

Table of Contents