LEMKEN Diamant 11 - Page 6

4
3.9.2 Requirements of the tractor ....................................................................................... 23
3.9.3 Axle loads .................................................................................................................. 24
3.9.4 Check before departure ............................................................................................. 28
3.9.5 Correct behaviour in road traffic ................................................................................ 29
3.10 Obligation of the operator .......................................................................................... 29
3.11 Safe use of the implement .......................................................................................... 30
3.11.1 General................................................................................................................... 30
3.11.2 Personnel selection and qualifications ................................................................... 31
3.11.3 Hydraulic system .................................................................................................... 32
4 Handing over the Implement .................................................................................. 33
5 Layout and description ........................................................................................... 34
5.1 Overview ...................................................................................................................... 34
5.2 Description ................................................................................................................... 35
5.2.1 Headstock .................................................................................................................. 35
5.2.2 Hydraulic cylinder for traction servo unit .................................................................... 35
5.2.3 Rotary cylinder ........................................................................................................... 35
5.2.4 Stabiliser .................................................................................................................... 36
5.2.5 Land wheel ................................................................................................................ 36
5.2.6 Frame ........................................................................................................................ 37
5.2.7 Plough body ............................................................................................................... 38
5.2.8 Additional tools .......................................................................................................... 40
6 Preparation of the Tractor ...................................................................................... 42
6.1 Tyres ............................................................................................................................. 42
6.2 Lift Rods ....................................................................................................................... 42
6.3 Check Chains or Sway Blocks of the Three Point Linkage ..................................... 42
6.4 Exterior width of the tractor ....................................................................................... 42
6.5 Control ......................................................................................................................... 42
6.6 Hydraulic equipment required .................................................................................... 43
7 Preparing the implement ........................................................................................ 44
7.1 Headstock attachment position ................................................................................. 44
7.2 Stand length ................................................................................................................. 45