Lenord+Bauer MiniCODER GEL 2444 - Cable Routing; Changes and Modifications; Electrostatic Discharge; Handling

3 Prevention of damage Lenord+BauerMiniCODER
48 GEL 2444
English
3 Prevention of damage and malfunctions
3.1 MiniCODER
3.1.1 Changes and modifications
Improper changes or modifications can damage the product.
 Do not make any changes or modifications to the product, with the exception of
the tasks described in these instructions.
3.1.2 Electrostatic discharge
Electrostatic discharge can irreparably damage the elec-
tronic components.
Only touch the connector pins and connection wires if
your body is suitably earthed, for example via an ESD
wrist strap.
3.1.3 Cable routing
The connection cable may be damaged if bent excessively.
 Pay attention to the minimum bending radius stated in the technical data.
3.1.4 Handling
The measuring surface is strongly magnetic. Impacts against the measuring surface
may occur if there are metallic objects close to the MiniCODER. This contact may
damage the sensor elements and result in the failure of the measuring system.
 Only remove the MiniCODER from the packaging immediately prior to mounting.
 Avoid impacts against the measuring surface by other objects.
 Pay attention to the mounting sequence.
3.1.5 Measuring surface
The measuring surface is printed with a protective layer. Removing the protective
layer can damage the measuring system.
 Do not remove the protective layer.