Lenze 8400 motec Series - Page 76

Lenze · Decentralised frequency inverter 8400 motec (CANopen option) · EDS84DMOTCAN EN 4.0 - 02/2019 75
Parameter reference
Parameters relevant for CANopen communication
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00347
C00349
Parameter | Name:
C00347 | CAN status HeartBeat producer
Data type: UNSIGNED_8
Index: 24228
d
= 5EA4
h
Display of the heartbeat producer's CAN status
Heartbeat protocol
( 66)
Selection list
0 Boot-up
4 Stopped
5 Operational
127 Pre-Operational
250 Failed
255 NoResponse
Subcodes Info
C00347/1 Status node 1
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C00349 | CAN setting DIP switch
Data type: UNSIGNED_16
Index: 24226
d
= 5EA2
h
Display of the DIP switch setting at the last time the mains connection was established
Possible settings via DIP switch
( 30)
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded:
Bit 0 Node address 1
Bit 1 Node address 2
Bit 2 Node address 4
Bit 3 Node address 8
Bit 4 Node address 16
Bit 5 Node address 32
Bit 6 Node address 64
Bit 7 Baud rate 1
Bit 8 Baud rate 2
Bit 9 Baud rate 4
Bit 10 Reserved
... ...
Bit 14 Reserved
Bit 15 Accept DIP switch 24V ON
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT