EasyManua.ls Logo

Lenze 9300 vector - Page 325

Lenze 9300 vector
466 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration
Code table
8
8.5
8.5−36
EDSVF9383V EN 4.0−03/2006
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0582 MONIT OH4 2
2 Warning
Configuration monitoring OH4,
heatsink temperature
l The operating temperature
can be set in C0122
See System
Manual
(extension)
3 Off
C0583 MONIT OH3 3
0 TRIP
Configuration of motor
temperature monitoring with
fixed operating temperature
l Only for KTY at X8
l The operating temperature is
fixed at 150 °C
6.6−11
See System
Manual
(extension)
2 Warning
3 Off
C0584 MONIT OH7 3
2 Warning
Configuration of monitoring
motor temperature with
variable operating temperature
l Only for KTY at X8
l When reaching the
temperature set in C0121 the
warning OH7 is activated
6.6−11
See System
Manual
(extension)
3 Off
C0585 MONIT OH8 3
0 TRIP
Configuration of motor
temperature monitoring
l Temperature monitoring via
PTC input (T1, T2)
6.6−9
See System
Manual
(extension)
2 Warning
3 Off
C0587 MONIT SD3 3
0 TRIP
Configuration of monitoring
SD3, encoder at X9
l Monitors the voltage supply
at X9/pin 8
See System
Manual
(extension)
2 Warning
3 Off
C0588 MONIT
H10/H11
0
0 TRIP
Configuration of monitoring
H10 and H11, thermal sensors in
the controller
l H10: Sensor error − heatsink
temperature
l H11: Sensor error − interior
temperature
See System
Manual
(extension)
3 Off
C0591 MONIT CE1 3
0 TRIP
Configuration of monitoring
CE1, communication error at
CAN−IN1
See System
Manual
(extension)
2 Warning
3 Off
C0592 MONIT CE2 3
0 TRIP
Configuration of monitoring
CE2, communication error at
CAN−IN2
2 Warning
3 Off
C0593 MONIT CE3 3
0 TRIP
Configuration of monitoring
CE3, communication error at
CAN−IN3
2 Warning
3 Off
C0594 MONIT SD6 3
0 TRIP
Activation of the motor
temperature monitoring with
KTY at X8
l Use C0594 = 0 or 2 to
activate monitoring
l In case of a short circuit or
interruption at X8/5 and
X8/8 the fault message SD6
is activated
l Configuration of the
response when exceeding the
motor temperature
Fixed operating
temperature in C0583
Variable operating
temperature in C0584
6.6−11
See System
Manual
(extension)
2 Warning
3 Off
efesotomasyon.com - Lenze

Table of Contents

Other manuals for Lenze 9300 vector

Related product manuals