Lenze 9300 vector - Page 331

Configuration
Code table
8
8.5

8.5−42
EDSVF9383V EN 4.0−03/2006
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0703

CFG: IN 19523 FCODE−472/3  Selection list 1 Configuration of analog input
signal, function block ANEG2
l The value at ANEG2−IN is
multiplied by −1 and output
See System
Manual
(extension)
C0704 DIS: IN −199.99 {0.01 %} 199.99 Function block ANEG2
l Display of the signal linked in
C0703
C0705 Function 1
1 IN1 = IN 2
Function selection, function
block CMP4
l Compare input signals at
CMP4−IN1 and CMP4−IN2
See System
Manual
(extension)
2 IN1 > IN2
3 IN1 < IN2
4 |IN1| = |IN2|
5 |IN1| > |IN2|
6 |IN1| < |IN2|
C0706 Hysteresis 1.00 0.00 {0.01 %} 100.00 Hysteresis, function block CMP4
l Hysteresis for input signals
which are not stable and
hence the output oscillates
C0707 Window 1.00 0.00 {0.01 %} 100.00 Window, function block CMP4
l Set the range in which the
signal comparison is to be
apply
C0708

 Selection list 1 Configuration of analog input
signal, function block CMP4
1 CFG: IN 1000 FIXED0% CMP4−IN1
2 CFG: IN 1000 FIXED0% CMP4−IN2
C0709 −199.99 {0.01 %} 199.99 Function block CMP4
l Display of the signals linked
in C0708
1 DIS: IN CMP4−IN1
2 DIS: IN CMP4−IN2
efesotomasyon.com - Lenze