Lenze 9300 vector - Page 349

Configuration
Code table
8
8.5

8.5−60
EDSVF9383V EN 4.0−03/2006
IMPORTANTPossible settingsCode
SelectionLenzeNameNo.
C0891

CFG: M−Add 1000 FIXED0%  Selection list 1 Configuration of analog input
signal, function block MCTRL
l Additional torque setpoint or
torque setpoint

8.2−40
C0892

CFG: Lo−M−LIM 5700 ANEG1−OUT  Selection list 1 Configuration of analog input
signal, function block MCTRL
l Lower torque limit in [%] of
C0057
C0893

CFG: HI−M−LIM 19523 FCODE−472/3  Selection list 1 Configuration of analog input
signal, function block MCTRL
l Upper torque limit in [%] of
C0057
C0898

CFG: M−LIM
switch
0
0 M−LIM ON Reduced torque
limit is active
Torque limitation in the field
weakening range, function block
MCTRL
l If the torque limit is reduced,
the maximum possible
torque in the field weakening
range is lowered with 1/f.
This provides a higher motor
stability in the field
weakening range

8.2−40
1 M−LIM OFF Reduced torque
limit is inactive
C0899

CFG:
N/M−SWT
1000 FIXED0  Selection list 2 Configuration of digital input
signal, function block MCTRL
l LOW = active speed control
l HIGH = active torque control

8.2−40
C0900

CFG: QSP 10250 R/L/Q−QSP  Selection list 2 Configuration of digital input
signal, function block MCTRL
l HIGH = drive performs quick
stop

8.2−25

8.2−40
C0901

CFG: I−SET 1000 FIXED0%  Selection list 1 Configuration of analog input
signal, function block MCTRL
l Setting of integral action
component of the speed
controller

8.2−40
C0902

CFG: I−LOAD 1000 FIXED0  Selection list 2 Configuration of digital input
signal, function block MCTRL
l HIGH = the integral action
component at MCTRL−I−SET is
accepted by the speed
controller
C0903

CFG: BOOST 5015 MCTRL−BOOST  Selection list 1 Configuration of analog input
signal, function block MCTRL
l Boost of the motor voltage

8.2−25
C0904

CFG:
DC−BREAK
1000 FIXED0  Selection list 2 Configuration of digital input
signal, function block MCTRL
l HIGH = Motor is braked

8.2−25

8.2−40
C0905 DIS: DC−BREAK 0 1 Function block MCTRL
l Display of the signal linked in
C0904
efesotomasyon.com - Lenze