Electrical installation
Wiring
Wiring terminal strips
5
117
EDK82EV222 DE/EN/FR 13.0
Wiring terminal strips
The supplied terminal strips are tested according to the specifications of
ƒ DIN VDE 0627:1986−06 (partially)
ƒ DIN EN 60999:1994−04 (partially)
Checked and tested are, for instance, mechanical, electrical and thermal load, vibration, damage of
conductors, loose conductors, corrosion, ageing.
Stop!
Proceed as follows to avoid damage of the terminal strip and the contacts:
ƒ Mount or remove only when the controller is not connected to the mains!
ƒ Wire the terminal strips before connecting them!
ƒ Unused terminal strips must also be plugged in to protect the contacts.
8200vec015
Note!
Basically wiring without wire end ferrules is possible.
If safety functions (e.g. "Safe torque off") are used, insulated wire end ferrules or rigid
conductors are required!
To Next Page
Loading...
Need help?
General