Lenze E82EV User Manual

Commissioning
Important codes for quick commissioning
7

146
EDK82EV222 DE/EN/FR 13.0
Code Possible settings IMPORTANT
No. Name Lenze Selection
C0002
*
!
uSEr
Parameter set
management
0 0 Ready PAR1 ... PAR4:
l Parameter sets of the controller
l PAR1 ... PAR4 also contain the
parameters for the function
modules standard I/O,
application I/O, AS interface,
system bus (CAN)
FPAR1:
l Module−specific parameter set of
the fieldbus function modules
INTERBUS, PROFIBUS−DP,
LECOM−B, DeviceNet/CANopen
l FPAR1 is saved in the function
module
Restoring the
delivery status
1 Lenze setting ð PAR1 Restore the delivery status in the
parameter set selected
2 Lenze setting ð PAR2
3 Lenze setting ð PAR3
4 Lenze setting ð PAR4
31 Lenze setting ð FPAR1 Restore the delivery status in the
fieldbus function module
61 Lenze setting ð PAR1 + FPAR1 Restore the delivery status in the
selected parameter set of the
controller and in the fieldbus
function module
62 Lenze setting ð PAR2 + FPAR1
63 Lenze setting ð PAR3 + FPAR1
64 Lenze setting ð PAR4 + FPAR1
C0002
*
!
uSEr
(Continu
ation)
Transferring
parameter sets
with the keypad
By means of the keypad you can
transfer the parameter sets to other
controllers.
During the transmission the access to
the parameters via other channels is
inhibited!
Keypad ð controller Overwrite all available parameter
sets (PAR1 ... PAR4, if required FPAR1)
with the corresponding data of the
keypad
70 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet, CANopen
10 with all other function modules

Lenze E82EV Specifications

General

Brand	Lenze
Model	E82EV
Category	DC Drives
Language	English