Lenze Global Drive 9300 Servo PLC Series - Page 67

9300 Servo PLC
System blocks
2.12 MCTRL_MotorControl
2-53
L
ServoPLC EN 2.0
Code IMPORTANTPossible settingsLCDCode IMPORTANT
SelectionLenze
LCD
[C0085] Mot Ls à Stray inductance of the motor
à depending on C0086
• Change of C0086 resets value to
the assigned default setting
• alteration sets C0086 = 0
0.00 {0.01 mH} 200.00
[C0087] Mot speed à Rated motor speed
à depending on C0086
• Change of C0086 resets value to
the assigned default setting
• alteration sets C0086 = 0
300 {1 rpm} 16000
[C0088] Mot current à Rated motor current
à depending on C0086
• Change of C0086 resets value to
the assigned default setting
• alteration sets C0086 = 0
0.5 {0.1 A} 500.0
[C0089] Mot frequency à Rated motor frequency
à depending on C0086
• Change of C0086 resets value to
the assigned default setting
• alteration sets C0086 = 0
10 {1 Hz} 1000
[C0090] Mot voltage à Rated motor voltage
à depending on C0086
• Change of C0086 resets value to
the assigned default setting
• alteration sets C0086 = 0
50 {1 V} 500
[C0091] Mot cos-phi (p.f.) à Motor cos ϕ
à depending on C0086
• Change of C0086 resets value to
the assigned default setting
• alteration sets C0086 = 0
0.50 {0.01} 1.00
efesotomasyon.com - Lenze
Show/Hide Bookmarks