Lenze i550

Control cabinet structure
Con
trol cabinet requirements
•
Protecon against electromagnec interferences
•
Compliance with the ambient condions of the installed components
Mounng plate requirements
•
The mounng plate must be electrically conducve.
-
Use zinc-c
oated
mounng plates or mounng plates made of V2A.
-
Varnished mounng plates are unsuitable, even if the varnish is removed from the con-
tact surfaces.
•
When using several mounng plates, make a conducve connecon over a large surface
(e. g. using grounding strips).
Arrangement of components
•
Division in
to power and control areas
Fig. 1: Example for the ideal arrangement of components in the control cabinet
Project planning
Con
trol cabinet structure
Arrangement of components
18