Lenze i550 - PTC Input

PTC input
In the Lenze
seng, motor temperature monitoring is acvated! In the delivery
status, there is a wire jumper between the terminals T1 and T2. Before connect-
ing a thermal sensor, remove the wire jumper.
Use Connecon of PTC or thermal contact
Connecon Terminal X109: T1
Terminal X109: T2
Sensor types PTC single sensor (DIN 44081)
PTC triple sensor (DIN 44082)
Thermal contact
X109
T1 T2
Terminal
descripon PTC input
Connecon X109
Connecon type pluggable screw terminal
Min. cable cross-secon mm² 0.5
Max. cable cross-secon mm² 1.5
Stripping length mm 6
Tightening torque Nm 0.2
Required tool 0.4 x 2.5
Product extensions
Mor
e control connecons
PTC input
84