Lenze L-force 9400 - Page 154

Single−axis controllers
Control terminals
3

154
EDS94SPP101 EN 10.2
Terminal X3 Labelling Description
GA GND analog signals
AO1 Analog output 1
AO2 Analog output 2
A1+ Analog input 1 +
A1− Analog input 1 −
A1− Analog input 1 −
A1R Terminating resistor for ±20mA
A2+ Analog input 2 +
A2− Analog input 2 −
SSP94000X3

Shield connection: Fix the shield with EMC wire clamp.
Terminal data
Conductor cross−section Tightening torque
[mm
2
] [AWG] [Nm] [lb−in]
Flexible
0.2 ... 2.5
24 ... 12 Spring terminal
With wire end
ferrule
 Note!
If the control terminals are completely wired, we recommend to use a cable
cross−section of max. 0.75 mm
2
to save space. The mechanical cover can then
be attached.