Regenerative power supply modules
Wiring
Earthing of internal EMC filters
6
321
EDS94SPP101 EN 10.2
Implementing the measures
Proceed as follows to disconnect the internal connection between the filters and PE:
1. Remove IT insulating cap from the parking position in the installation backplane.
– For this apply a screwdriver on the right or left and lever off the insulating cap.
– Optionally the insulating cap can be carefully removed using an appropriate pliers.
2. Attach IT insulating cap to the earthing jumper until it clicks into place.
1
2
SSP94IT001
Fig. 6−8 Plugging the IT insulating cap onto the earthing jumper
To Next Page
Loading...
