Single−axis controllers
General data and operating conditions
3
34
EDS94SPP101 EN 10.2
Protection of persons and device protection
Type of protection
EN 60529 IP 20
Outside the wire range of
the terminals on the
motor side
NEMA 250 Protection against accidental
contact in accordance with
type 1
Insulation resistance EN 61800−5−1 Overvoltage category III
from 2000 m amsl: external measures for compliance with
the overvoltage category II are required, e.g.
upstream connection of transformer
upstream connection of overvoltage protection system
Control circuit isolation EN 61800−5−1 up to 2000 m amsl:
Safe mains isolation by double/reinforced insulation for
mains with neutral earthing with a rated voltage for the
external conductor/star point up to 300 V.
from 2000 m amsl:
If an overvoltage protection system is connected upstream to
the device, additional external measures are required for
maintaining the safe isolation.
Short−circuit strength EN 61800−5−1 Motor connection: with restrictions, error acknowledgement
required
Control terminals: full
Motor − protective
measures against
Short circuit
Earth fault
Overvoltage
motor stalling
Motor overtemperature
(PTC or thermal contact, I
2
t monitoring)
Leakage current EN 61800−5−1 > 3.5 mA AC, > 10 mA DC Observe regulations and
safety instructions!
Cyclic mains switching Cyclic mains switching of 5 times in 5 minutes is permissible
without restrictions.
Design
Housing
Carrier housing
Device sizes
1, 2 and 3
Glass−fiber reinforced plastic
Carrier housing Device sizes
as of 6
Metal
Dimensions see "Mechanical installation"
Weight see "Mechanical installation"
Mounting conditions
Mounting place
in the control cabinet
Mounting position vertical
Clearance
above/beneath
Comply with the device−relating mounting instructions.
at the side
Can be installed in a row without any clearance
To Next Page
Loading...
