Index
111 Lenze · E84AYCPM communication module (PROFIBUS®) · Communication Manual · DMS 5.0 EN · 11/2012 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
A
Abort of data transfer by the inverter (DP-V0) 55
Access to process data 45
Activating the bus terminating resistor 27
Active station address (C13864) 98
Acyclic data transfer (DP-V1) 63
Addressing of Lenze parameters/parameter data 51
All words from master (C13851) 95
All words from standard device (C13853) 96
All words to master (C13850) 95
All words to standard device (C13852) 96
Application as directed 13
Application notes 10
Application of the communication module 13
Approvals 15
B
Baud rate 15
Baud rate (C13863) 97
Before initial switch-on 30
Bus cable length 28
Bus counter (C13862) 97
Bus device type 15
Bus status (C13861) 97
C
C13850 | All words to master 95
C13851 | All words from master 95
C13852 | All words to standard device 96
C13853 | All words from standard device 96
C13860 | Settings 96
C13861 | Bus status 97
C13862 | Bus counter 97
C13863 | Baud rate 97
C13864 | Active station address 98
C13865 | Display: Most recent PRM data 98
C13866 | Display: Most recent CFG data 98
C13867 | Display: Most recent diagnostic data 98
C13880 | Reaction on communication fault 99
C13881 | Monitoring time: Data exchange 99
C13882 | Monitoring time: Watchdog 100
C13885 | Clear process data 100
C13886 | Set ext. diagnostic bit upon 100
C13887 | Suppress signalling diag. mess. upon 101
C13899 | Station address 101
C13900 | Firmware product type 101
C13901 | Firmware compilation date 101
C13902 | Firmware version 102
C13920 | Display: DIP switch setting 102
Cable length 15
Clear process data (C13885) 100
Codes 95
Commissioning 30
Communication channels 44
Communication medium 15
Communication profile 15
Communication time 19
Configuration of the controller (master) 31
Configuration of the master 31
Configuration of the PROFIBUS master 31
Configuring the port interconnection in the »Engineer« 47
Conformities 15
Connection establishment between master and slave (DP-V1)
62
Connection to 8400 standard device lost (error message) 92
Consistent parameter data 80
Conventions 8
Conventions used 8
D
Data transfer 44
Data transfer abort by the master (DP-V0) 55
Defining the user data length 31
Device- and application-specific safety instructions 12
Device data base file 31
Device protection 12
Diagnostic message 89
Diagnostics 84
Diagnostics with the »Engineer« 87
Dimensions 20
DIP switch positions for setting the station address 107
Display
DIP switch setting (C13920)
102
Most recent CFG data (C13866) 98
Most recent diagnostic data (C13867) 98
Most recent PRM data (C13865) 98
Document history 7
DP states for short-time interruption of communication 82
DP-V0 52
DP-V1 61
DRIVECOM 52
DRIVECOM parameter data channel (DP-V0) 52
Index
To Next Page
Loading...
