Lenze PROFINET 9400

13 Error messages
13.2 Possible causes and remedies
90
Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 11.0 EN · 04/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
PROFINET: "Data_Exchange" status quit [0x00c88131]
Response (Lenze setting printed in bold) Setting: C13880/1 / C14880/1 ( Configurable response)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The data exchange via PROFINET has been terminated.
Also see the chapter "Interruption of PROFINET
communication" ( 77).
• Check cables and terminals.
• Plug in the network cable on the PROFINET terminal
X241/X242.