Wireless Access Point User Guide
12
7. From the menu, check the following screens, and configure as necessary for your
environment. Details of these screens and settings are described in the following
sections of this chapter.
System - Basic and Advanced settings
Wireless - Basic, Advanced, Access Control, Radius Server, Virtual APs &
WIFI Protected Setup.
8. You may also wish to set the admin password and administration connection
options. These are on the Admin Login screen accessed from the Management
menu. See Chapter 6 for details of the screens and features available on the
Management menu.
9. Use the Apply and Reboot buttons on the menu to apply your changes and restart
the Wireless Access Point.
Setup is now complete.
Wireless stations must now be set to match the Wireless Access Point. See Chapter 4
for details.
If you can't connect:
It is likely that your PC’s IP address is incompatible with the Wireless
Access Point’s IP address. This can happen if your LAN does not have a
DHCP Server.
The default IP address of the Wireless Access Point is 192.168.1.1, with a
Network Mask of 255.255.255.0.
If your PC’s IP address is not compatible with this, you must change your
PC’s IP address to an unused value in the range 192.168.1.50 ~
192.168.1.200, with a Network Mask of 255.255.255.0. See Appendix C -
Windows TCP/IP for details for this procedure.
To Next Page
Loading...
