82
Appendix C
Windows TCP/IP
Overview
Normally, no changes need to be made.
By default, the Wireless Access Point will act as a DHCP client, automatically
obtaining a suitable IP Address (and related information) from your DHCP Server.
If using Fixed (specified) IP addresses on your LAN (instead of a DHCP Server),
there is no need to change the TCP/IP of each PC. Just configure the Wireless
Access Point to match your existing LAN.
The following sections provide details about checking the TCP/IP settings for various
types of Windows, should that be necessary.
Checking TCP/IP Settings - Windows 9x/ME:
1. Select Control Panel - Network. You should see a screen like the following:
Figure 64: Network Configuration
2. Select the TCP/IP protocol for your network card.
3. Click on the Properties button. You should then see a screen like the following.
To Next Page
Loading...
