User Guide
Leviton MLC 16D Motorized Lighting Controller Page 9 of 62
62
Inverting Traits
You can invert individual continuous traits of an assigned fixture using the Assign
Fixture menu. Traits of a fixture assigned to more than one Fixture button can
operate opposite from each other.
To make changes:
1
Press Edit.
2
Press F4, above Setup.
3
Press F2, above Fixture.
4
Press F3, above Assign.
5
Turn Modify wheel 4 to move from Edit to Invert.
6
Press F4, above Select <Invert>.
7
Turn Modify wheel 2 to scroll through the fixture traits.
Note:
Only continuous traits can be inverted. This inversion is in addition
to any defined within the fixture definition and will revert any trait that is
inverted in the definition. For example, if pan is inverted in the fixture
definition and then inverted again at assignment, it will operate as if it
was not inverted at all.
8
When the desired trait is shown on the LCD display, press F4, above
Select <Edit>.
9
Turn Modify wheel 3 to choose Yes or No.
10
Press F4, above Select <Save>, or turn Modify wheel 4 to Select
<Cancel> to cancel the action.
11
When you have inverted all the desired traits, press Blackout or Edit to
exit Setup mode.
Defining Fixtures
One of the keys to the ease of use of the MLC 16D is the ability to define
personalities for fixtures you wish to control. Instead of having to remember that
a fixture starts on channel 50, and that the dimmer trait is the seventh channel of
the fixture making it channel 56, you simply have to press the assigned Fixture
Select button and rotate the Modify wheel labeled Dimmer until the desired
value has been reached.
Ch 1 Ch 2 Ch 3 Ch 4 Ch 5 Ch 6 Ch 7
1 2 3 510 511 512
. . . . . .
50 51 52 53 54 55 56
Pan DimmerTilt Color
Gobo
DMX512 dimmers
To Next Page
Loading...
