Leviton MLC16 - Recording Patterns Using Manual Control; Editing Patterns

User Guide
Page 26 of 62 Leviton MLC 16D Motorized Lighting Controller
62
8 Turn Modify wheel 4 to select Fullstep or Scnstep.
Note: In All Traits mode you can only record Fullsteps. In Selective Traits
mode each pattern step can have up to ten scenes layered together.
9 Turn Modify wheel 2 to select the desired scene.
Note: In Scene Step mode, turn Modify wheel 1 to select Count 2, and
enter the next scene; continue until you have entered the desired number
of scenes.
10 Press the More buttons, then press F4, above Rec, or press the Record
button.
The step is recorded.
11 Record more steps, following this procedure.
12 When finished, press the Blackout or Edit button to exit Record mode.
Recording Patterns Using Manual Control
To record a pattern using manual (live) control of the device:
1 Press the Record button.
The LED on the button lights, and you enter Record mode.
2 Press F2, above Pattern.
3 Turn Modify wheel 1 to select the pattern to be recorded.
4 Turn Modify wheel 4 to select the recording mode, Select or All traits.
5 Press F4, above Traits.
6 Turn Modify wheels 1, 2, and 3 to modify the fade, hold, and delay times.
7 Press any of the Fixture or Group buttons for the desired device or
group.
8 Press the Select button for the desired device or group.
The LCD display shows the traits, and you have control of the fixture(s).
Note: In the Selective Traits mode, only those traits captured (indicated
by an asterisk beside a trait value when a device is selected) will be
recorded. Whenever a device is selected with no pattern or show active,
all traits for that device are immediately captured.
9 Set the desired look on stage with all necessary groups and devices.
10 Press the Record button.
11 Repeat the previous two steps to record more pattern steps.
12 When finished, press the Blackout or Edit button to exit Record mode.
Editing Patterns
You can edit patterns to modify the scenes they contain, as well as fade, hold,
and delay times of each step, or insert or remove pattern steps.
To edit a pattern:
1 Press the Edit button.
2 Press F2, above Pattern.
3 Turn Modify wheel 1 to select the pattern to be edited.
4 Press F4, above Select Edit.
5 Turn Modify wheel 4 to select the pattern step to edit.
6 Turn Modify wheels 1, 2, and 3 to modify the fade, hold, and delay times.