Diagnostic information 2-5
2580+, 2581+, 2590+, 2591+
Error indications
Operator panel problems
Paper feed problems
Symptom Action
Ready and Paper Out lights blink. Turn the printer off and then back on.
Go to “Abnormal indications” on page 2-4.
Paper Out and Font
lights blink.
Turn the printer off and then back on.
Go to “Irrecoverable operator errors” on page 2-7.
Symptom Action
The Start/Stop button does not function,
but no error is indicated.
Only the Power light turns on.
One or more buttons do not function.
One or more lights do not function.
Turn the printer off and then back on.
Go to “Operator panel service check” on page 2-13.
Symptom Action
The Paper Out light is blinking when
there is paper in the printer.
Go to “Paper Present sensor service check” on page 2-13.
The Paper Out light does not blink when
there is no paper in the printer and the
ASF is not installed.
Print operation starts without paper.
Be sure the paper present sensor is not blocked.
Go to “Paper Present sensor service check” on page 2-13.
The Load/Unload button does not
function when the push tractor is
installed.
Form feed length is not correct.
The Load/Unload button functions when
cut sheets are being used.
Be sure the Paper Select lever is in the correct position.
Go to “Paper Select sensor service check” on page 2-15.
Continuous forms feed, but cut sheets
fail to load.
Be sure the Paper Select lever is in the cut sheet position.
Verify that continuous forms have been parked using the Load/Unload
button.
Be sure Auto Cut Sheet is enabled in the Setup mode.
Go to “Paper Select sensor service check” on page 2-15.
The Load/Unload button functions when
the pull tractor is installed.
The Paper Out light blinks, and the
FormFeed button does not operate until
paper is located at first print line.
Be sure the Paper Select lever is in the tractor position.
Go to “Pull Tractor sensor service check” on page 2-18.
To Next Page
Loading...
