Repair information 4-15
2580+, 2581+, 2590+, 2591+
13. Lift the carrier at the angle shown, and carefully remove the carrier from the printer.
Note: Following replacement, perform the printhead-to-platen gap adjustment. Go to “Printhead-to-platen gap
adjustment” on page 4-2.
Carrier fan removal
1. Remove the rear cover. See “Covers, rear removal” on page 4-5.
2. Remove the top cover. See “Covers, top removal” on page 4-5.
3. Disconnect the carrier fan cable (A) from the logic board.
To Next Page
Loading...
