4-26 Service Manual
2580+, 2581+, 2590+, 2591+
6. Unplug the two connectors (C) from the logic board and ease the cable off the printer.
Note: Be sure the printhead cables are correctly aligned and secured. They must be flat with no twists.
Ribbon drive rack gear removal
1. Remove the rear cover. See “Covers, rear removal” on page 4-5.
2. Remove the top cover. Go to “Covers, top removal” on page 4-5.
3. Remove the carrier. Go to “Carrier removal” on page 4-12.
4. Unsnap the white plastic end stop (A) from the top left side of the print unit.
5. Unlatch the left side of the rack from the top of the print unit.
6. Slide the rack to the right and out of the print unit.
To Next Page
Loading...
