Lexmark 2591+ - Sensor (Pull Tractor and Paper Select) Removal

Repair information 4-35
2580+, 2581+, 2590+, 2591+
Go Back
Previous
Next
5. Remove the screw (C) securing the head gap sensor.
6. Ease the sensor (head gap and home position) off the printer, and remove.
Note: Pay attention to the original routing of the cable.
Sensor (pull tractor and paper select) removal
1. Remove the rear cover. See “Covers, rear removal” on page 4-5.
2. Remove the top cover. See “Covers, top removal” on page 4-5.
3. Remove the INA support frame. See “INA support frame removal” on page 4-8.
4. Remove the print unit. See “Print unit removal” on page 4-21.
5. Remove the two small screws (A) securing the two sensors.
6. Remove the sensor (pull tractor and paper select).
C
A