Repair information 4-25
2580+, 2581+, 2590+, 2591+
3. Disconnect the two cables (B) and remove the printhead.
Note: Be sure the printhead cables are correctly aligned and secured. Be sure to perform the printhead-to-
platen gap adjustment. See “Printhead-to-platen gap adjustment” on page 4-2.
Printhead cable removal
1. Remove the ribbon access cover. See “Covers, ribbon access removal” on page 4-5.
2. Remove the printhead. See “Printhead removal” on page 4-24.
3. Remove the rear cover. See “Covers, rear removal” on page 4-5.
4. Remove the top cover. See “Covers, top removal” on page 4-5.
5. Remove the clip (A) holding the printhead cable.
Note: Pay attention to how the ends (B) of the clip are engaged to the carrier slots.
To Next Page
Loading...
