3-8 Service Manual
2580+, 2581+, 2590+, 2591+
Setup mode
Entering Setup mode
1. Open the operator panel cover to access layer two.
2. Press Setup to put the printer in Setup mode and print the Main Menu.
3. Press LineFeed to print a list of all the available options.
4. Select any option from the Main Menu by pressing the corresponding button. A new menu prints each time
you press a button, displaying new selections.
5. After making a selection, the printer prints a page with the changes shown.
Exiting Setup mode
1. Press Set TOF until the printer returns to the Main Menu, or press Pitch from any menu containing a
Return to Main Menu selection.
2. Press Set TOF again to exit Setup mode. New settings are saved only when the printer exits Setup mode.
Note: If the printer runs out of paper while in Setup mode, load more paper into the tractor pins, and press
Setup to continue.
Setup menu options
Interface menu options
Menu Function
Forms Macro options Customize macros to print a variety of forms.
Data options Define how information is processed.
Control options Define how the printer performs basic tasks.
Emulation options Determine how the printer interacts with
software applications.
Interface options Define how information is transferred from a
computer to the printer.
Menu Function
Interface • Automatically select the printer interface.
• Use the parallel cable.
• Use the USB cable.
• Use the serial cable (only appears if
optional serial adapter is installed).
Honor init • Enable honors the init signal on the
parallel port.
• Disable ignores the init signal on the
parallel port.
To Next Page
Loading...
