Diagnostic aids 3-5
2580+, 2581+, 2590+, 2591+
Web page at a glance
The 2500 series internal web server enables a user or service technician to view and adjust the device settings.
The web page can be accessed by opening a web browser and pointing it to the IP address of the networked
printer.
The Device Status, Configuration and Reports pages are the commonly used pages to view printer settings and
make adjustments to the settings.
Device settings
The Device Status Page presents an at-a-glance summary of essential information about the status of the
device.
Configuration page
This page displays numerous links that enable users to access and (with proper permissions) to change various
device settings.
Changing a configuration setting:
1.
From the Configuration page, click the appropriate link to access the desired device setting.
2. Make the desired changes to the selected setting.
3. To save the changes as the new device faults, click Submit. Or, to cancel any changes and restore all
fields on the form to their original values, click Reset.
Note: Changes to network settings of the device should only be performed by the network administrator.
Reports page
The Reports page contains the following links:
• Print server setup
The Print Server Setup page lists important print server information (for example, hardware
addresses, firmware revision level, protocol settings, and so on.)
• Network setup
Network protocol settings are displayed. Adjustments can also be made to settings here.
To Next Page
Loading...
