Lexmark 2591+ - Carrier Removals; Carrier Removal

4-12 Service Manual
2580+, 2581+, 2590+, 2591+
Go Back
Previous
Next
Carrier removals
Carrier removal
1. Remove the ribbon access cover. See “Covers, ribbon access removal” on page 4-5.
2. Remove the printhead assembly. See “Printhead removal” on page 4-24.
3. Remove the rear cover. See “Covers, rear removal” on page 4-5.
4. Remove the top cover. See “Covers, top removal” on page 4-5.
5. Remove the forms thickness lever. See “Forms thickness lever removal” on page 4-19.
6. Remove the clip (A)holding the printhead cable.
Note: Pay attention to how the ends (B) of the clip are engaged to the carrier slots.
7. Loosen the carrier belt:
7.1 Loosen the tension screw (C).
7.2 Remove tension from the belt by pulling up on the belt.
A B