Lexmark E120 - Setup; Usb

Diagnostic aids 3-9
4506-1xx
Setup
Use the Setup menu to configure how the printer formats the end of a line depending on the computer system
being used.
USB
Use the USB menu to change printer settings on jobs sent through a USB port.
Menu item Use this setting to Values
Demo Mode Put the printer into demo mode where internal
sheets print with each press of .
To deactivate, turn the printer off, and re-enter the
configuration group. Set to Deactivate.
Deactivate (default)
Activate
Auto CR After LF Specify whether the printer automatically performs
a carriage return after a line feed control
command.
Off (default)
On
Auto LF after CR Specify whether the printer automatically performs
a line feed after a carriage return control
command.
Off (default)
On
Energy Conserve On
Off (default)
Menu item Use setting to Values
NPA Mode Send print jobs to the printer and query printer
status information simultaneously.
Off
On
Auto (default)
MAC Binary PS Configure the printer to process Macintosh binary
PostScript print jobs.
Off—The printer filters
PostScript print jobs using
Standard protocol.
On—The printer processes
raw binary PostScript print
jobs from computers using
the Macintosh operating
system. This setting often
causes Windows print jobs to
fail.
Auto (default)—The printer
processes print jobs from
computers using either
Windows or Macintosh
operating systems.