4-4 Service Manual
4506-1xx
Removal procedures
CAUTION: Remove the power cord from the printer or electrical outlet before you connect or
disconnect any cable, electronic board, or assembly for personal safety and to prevent damage to
the printer. Disconnect any connections between the printer and PCs/peripherals.
Note: Some removal procedures may require removing cable ties. If so, you must replace the cable ties during
reassembly to avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Note: Before beginning any removal, remove the toner cartridge and PC kit.
Warning: Cover the PC kit to block light to the PC drum. It can be damaged by excessive light.
Extender cover removal
1. Rotate the extender cover (A) toward the front of the printer.
2. Pinch the pivot on the extender cover and remove it.
Tray cover removal
Lift and pull out the tray cover.
A
To Next Page
Loading...
