Diagnostic information 2-11
4506-1xx
Additional information—primary codes
The following tables explain the primary light patterns (or codes), the secondary error codes, what these codes mean,
and how to clear them. User attendance and status information is included. For service information, see “Service
codes” on page 2-17.
z ✷ z PPDS font error
z z z Defective flash
z ✷ z Insufficient defrag memory
z z z Network interface errors
z ✷ z ENA connection lost
z z z z Memory full
z z z z Short paper
✷✷✷✷✷✷Service error see “Service codes” on page 2-17
Primary codes—additional information
Description/
Light pattern
Meaning Action
Ready/Power Saver • Printer is ready to receive and
process data.
• Printer is in Power Saver
mode.
• Send a print job.
• Press to print the menu settings pages for
a list of current printer settings.
• Press and hold to reset the printer.
Note: To change the Power Saver setting, use
the Local Printer Setup Utility. See the User’s
Reference for more information.
Busy • Printer is busy receiving and
processing data or printing.
• Printer is formatting the flash
memory.
• Printer is storing resources,
such as fonts or macros, in
flash memory.
• Printer is printing a directory, a
font list, menu settings pages,
or Print Quality Test Pages.
• Busy:
– Wait for the message to clear.
– Press and release to cancel the print
job.
– Press and hold to reset the printer.
• Printing a directory, a font list, menu settings
pages, or Print Quality Test Pages:
– Wait for the pages to print. The Busy
message is displayed as the pages print.
The light is on when printing stops.
– Press and release to cancel printing.
– Press and hold to reset the printer.
• Receiving/processing data from a host
interface:
– Wait for the message to clear.
– Press and release to stop processing.
– Press and hold to reset printer.
Hex Trace Ready Printer is in the Ready mode and
Hex Trace is active.
• Hex Trace helps troubleshoot printing
problems. After resolving the problem, turn off
the printer to exit Hex Trace.
• Or, press and hold to reset the printer.
z
✷
x
To Next Page
Loading...
