3-10 Service Manual
4506-1xx
Network
Use the network menu to change printer settings on jobs sent through a network port (either standard network or
network opt <x>).
Menu item Use setting to Values
NPA Mode Send print jobs to the printer and query printer
status information simultaneously.
Off
Auto (default)
MAC Binary PS Configure the printer to process Macintosh binary
PostScript print jobs.
Off—The printer filters
PostScript print jobs using
Standard protocol.
On—The printer processes
raw binary PostScript print
jobs from computers using
the Macintosh operating
system. This setting often
causes Windows print jobs to
fail.
Auto (default)—The printer
processes print jobs from
computers using either
Windows or Macintosh
operating systems.
Set Card Speed Automatically detect the connection speed of your
network.
This setting can be disabled to set the speed
manually.
Auto (default)—The printer
detects the current network
speed.
10Mbps, half duplex—Forces
the printer to try to connect to
the network only at 10Mbps,
half duplex.
10Mbps, full duplex—Forces
the printer to try to connect to
the network only at 10Mbps,
full duplex.
100Mbps, half duplex—
Forces the printer to try to
connect to the network only
at 100Mbps, half duplex.
100Mbps, full duple—Forces
the printer to try to connect to
the network only at 100Mbps,
full duplex.