4 Set the color, quality, original image size, and the other scan options. If necessary, press each time you make
a selection.
5 Press .
The scan is complete when a message appears on the printer control panel indicating that the file you scanned has
been saved.
Scanning to a network computer
1 Load the original document.
2 From the printer control panel, navigate to:
> Scan > > Computer
3 Press the left or right arrow button to manually select the name of the destination computer, and then press .
Notes:
• You may be prompted to enter a PIN if the computer requires it.
• To assign a computer name and a PIN to the computer, see the Help for the printer software associated with
your operating system.
4 Select the output file type you want to create and other scan options. If necessary, press each time you make
a selection.
5 Press .
The scan is complete when a message appears on the printer control panel indicating that the file you scanned has
been saved.
Scanning to a flash drive or memory card
Notes:
• Some features are available only in select models.
• Before you begin, make sure your flash drive or memory card is not write‑protected.
1 Load the original document.
2 From the printer control panel navigate to:
> Scan > > Memory Device >
3 Insert the flash drive or memory card.
Notes:
• The printer reads only one memory device at a time.
• If a flash drive is inserted into the USB port while a memory card is in the card slot, then a message appears
on the display prompting you to select which memory device to use.
4 Press the up or down arrow button to scroll to the file type you want to scan.
Scanning
65
To Next Page
Loading...
