Repair information 4-25
7011-2xx
Input roller clutch and lever removal (autocompensator clutch)
1. Remove the left side cover. See “Left side cover removal” on page 4-4.
2. Place the MFP on its right side. Protect the cover from being marred.
3. Remove four screws (A) in the gear train metal cover.
4. Remove the screw (B) from the shaft of the input roller clutch assembly.
5. Remove the screw and lever (pawl) (C).
6. Remove the clutch assembly. If the pieces come apart, they can be easily reassembled if necessary.
To Next Page
Loading...
