4-28 Service Manual
7011-2xx
LVPS/HVPS card assembly removal
Note: If you
1. Remove the cover extender (if installed), paper tray, and the rear cover. See “Rear cover removal” on
page 4-5 for more information.
2. Remove two screws (A), one left of the power switch and the other at the opposite side of the panel.
3. Place the MFP onto its back with the rear and bottom of the MFP in view.
4. Remove the screws (B) securing the two foot brackets.
5. Remove four screws (C) in the bottom of the metal cover.
To Next Page
Loading...
