4-36 Service Manual
7011-2xx
Printhead removal
1. Remove the top cover. See “Top cover removal” on page 4-8 for more information.
2. Remove the toroid from the group of cables at the top of the controller card.
3. Unplug the printhead cables at locations J12 and J13 on the controller card and on the printhead.
4. Remove three screws (A) that secure the printhead to the cross brace, and lift the printhead out.
Note: Notice the alignment of the printhead at each screw before removing the screws.
Note: Printer registration must be set after replacing the printhead. See “Registration” on page 3-3.
To Next Page
Loading...
